Setting TPS - by Cannondale27

 

 

Text Box:  
First thing is to receive cal from ECU

 

 

 

Text Box: WRITE THESE NUMBERS DOWN

 

Text Box: Select injector cal only

 

 

 

 

 

 

 


 

Text Box: 1)Now you are ready to click Set Throttle Position.
 
2)Click read closed voltage
 
3)Take slack out of throttle cable and hold wide open or better push throttle wheel all the way open and then click WOT voltage. Best to have a helper click for you.
 
4)If in range click accept values. If not repeat process.
 
.

 

  

Text Box: Self explanatory

 

 

 

 

 


 

 

Text Box: File means the settings you just did you will want to check TPS closed and open if they are different. Make sure the rest of numbers match values you wrote down. Click OK.

 

 

 

 

Text Box: You will see blue graph in upper right corner when done fuel pump will cycle.

 

 

 

 

 

Text Box: 1)Click Monitor.
2) Raise the throttle% by 3. (Turning idle screw in)
3) Start it up
4) Watch stepper position when it stops going up set your idle to at least 2100rpm it fluctuates get it as close as you can but make sure it doesn’t go below that.
 
(As you can see this battery is way low need to put on charger)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 


 

 

 

 

  

 

 

 

 

 


 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 
 

 


.

 The CannondaleRiders.com Store!
  • SECURE ONLINE ORDERING!
  • UPS SHIPPING AVAILABLE!
  • MORE PRODUCTS!
  • LOW PRICES!
Now Online!

Help Support this site!

 

Order your Cannondaleriders.com Tee shirt